Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
86160Y
1.INSTALL REAR NO. 2 SPEAKER ASSEMBLY
Temporarily install the speaker by attaching the 2 claws of the speaker to the door panel.
Install the speaker with the 3 screws.
Connect the connector.
Do not touch the cone of the speaker.
64780A
2.INSTALL BACK DOOR TRIM PANEL ASSEMBLY
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).