Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64780A
2.REMOVE BACK DOOR TRIM PANEL ASSEMBLY
86160Y
3.REMOVE REAR NO. 2 SPEAKER ASSEMBLY
Disconnect the connector.
Remove the 3 screws.
Detach the 2 claws and remove the speaker.
Do not touch the cone of the speaker.