Home › Audio / Visual / Telematics › AUDIO / VIDEO › MULTI-MEDIA INTERFACE ECU › 2009.08–2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274035 MULTI-MEDIA INTERFACE ECU A

AUDIO / VIDEO  MULTI-MEDIA INTERFACE ECU  INSTALLATION  


PROCEDURE

Hide 861A2 1.INSTALL NO. 1 MULTI-MEDIA INTERFACE BRACKET

a.

Install the No. 1 multi-media interface bracket with the bolt.


Hide 861A3 2.INSTALL NO. 2 MULTI-MEDIA INTERFACE BRACKET

a.

Install the No. 2 multi-media interface bracket with the bolt.


Hide 861A1 3.INSTALL MULTI-MEDIA INTERFACE ECU

a.

Install the multi-media interface ECU with the 2 nuts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


b.

Connect the connector.


Hide 55303B 4.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 55607 7.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55475A 8.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).