Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274040 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  INSTALLATION  


PROCEDURE

Hide 86101J 1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof)

a.

Apply new double-sided tape as shown in the illustration.

HINT:

Attach double-sided tape to the hatched areas shown in the illustration below.


B240368E01
2.645,5.51 2.779,5.678 0.134,0.167 10 A 0.604,0.35 0.725,0.506 0.121,0.156 10 B

Text in Illustration
V100143

Marking Tape
V100155

Double-sided Tape


b.

Align the marking tape wound around the No. 2 antenna cord sub-assembly with the protrusion on the roof headlining assembly in the illustration labeled A and attach the No. 2 antenna cord sub-assembly to the double-sided tape.


c.

Align the marking tape wound around the No. 2 antenna cord sub-assembly with the V markings on the roof headlining assembly at the 6 locations shown and attach the No. 2 antenna cord sub-assembly to the double-sided tape.


d.

Attach the clamp shown in the illustration labeled B.


Hide 86101J 2.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof)

a.

Apply new double-sided tape as shown in the illustration.

HINT:

Attach double-sided tape to the hatched areas shown in the illustration below.


B240365E01
0.611,0.351 0.728,0.490 0.117,0.139 10 B 2.664,5.526 2.784,5.686 0.120,0.159 10 A

Text in Illustration
V100143

Marking Tape
V100155

Double-sided Tape


b.

Align the marking tape wound around the No. 2 antenna cord sub-assembly with the protrusion on the roof headlining assembly in the illustration labeled A and attach the No. 2 antenna cord sub-assembly to the double-sided tape.


c.

Align the marking tape wound around the No. 2 antenna cord sub-assembly with the V markings on the roof headlining assembly at the 6 locations shown and attach the No. 2 antenna cord sub-assembly to the double-sided tape.


d.

Attach the clamp shown in the illustration labeled B.


Hide 63310 3.INSTALL ROOF HEADLINING ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).