Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274040 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 63310 2.REMOVE ROOF HEADLINING ASSEMBLY

Hide 86101J 3.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof)

a.

Detach the clamp to remove the No. 2 antenna cord sub-assembly from the roof headlining assembly.

B240364


b.

Remove the double-sided tape from the roof headlining assembly.


Hide 86101J 4.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof)

a.

Detach the clamp to remove the No. 2 antenna cord sub-assembly from the roof headlining assembly.

B240367


b.

Remove the double-sided tape from the roof headlining assembly.