The clearance warning buzzer sounds to alert the driver. The sounding pattern changes depending on the distance to an obstacle.
Disconnect the F78 clearance warning ECU assembly connector.
Disconnect the F79 No. 1 clearance warning buzzer connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F78-19 (CBZ) - F79-1 | Always | Below 1 Ω |
| F78-20 (EF) - F79-2 | Always | Below 1 Ω |
| F78-19 (CBZ) - Body ground | Always | 10 kΩ or higher |
| F78-20 (EF) - Body ground | Always | 10 kΩ or higher |
OK
NG
Temporarily replace the No. 1 clearance warning buzzer with a new or normally functioning one (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING BUZZER>REMOVAL).
Check that the clearance warning buzzer sounds properly when the TOYOTA parking assist-sensor system detects an obstacle.
Buzzer sounds properly.
OK
NG