Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056151 PARK ASSIST / MONITORING _0274044 CLEARANCE WARNING ECU A

PARK ASSIST / MONITORING  CLEARANCE WARNING ECU  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67920 2.REMOVE DOOR SCUFF PLATE ASSEMBLY LH

Hide 55474C 4.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55045 5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 89340A 6.REMOVE CLEARANCE WARNING ECU ASSEMBLY

a.
E198645

Disconnect the connector.


b.

Remove the bolt and clearance warning ECU assembly.