Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67492A
2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69298A
3.REMOVE DOOR NO. 2 INSIDE HANDLE BEZEL LH
67602
4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
5.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
67832
6.REMOVE FRONT DOOR SERVICE HOLE COVER LH
68102
7.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
68151E
8.REMOVE FRONT DOOR GLASS RUN LH
67404F
9.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
69217F
10.REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH
69040A
11.REMOVE FRONT DOOR LOCK ASSEMBLY LH
Disconnect the connector.
Using a T30 "TORX" wrench, remove the 3 screws.
Slide the front door lock assembly downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock assembly and cables as a unit.
Remove the front door lock open rod from the front door lock assembly.
Remove the door lock wiring harness seal from the front door lock assembly.
69720B
12.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
69760C
13.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH