Home › Vehicle Exterior › DOOR / HATCH › FRONT DOOR › 2009.08–2013.08
RM1440E _59 Vehicle Exterior _056168 DOOR / HATCH _0274178 FRONT DOOR A

DOOR / HATCH  FRONT DOOR  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67492A 2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

a.
B240255

Detach the 2 clips and remove the front door lower frame bracket garnish LH.


Hide 69298A 3.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

a.
B240256

Using a moulding remover, detach the 3 claws and remove the inside handle bezel as shown in the illustration.


Hide 67602 4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

a.
B240257

Detach the 4 claws and 2 door armrest caps.


b.
B240258

Remove the 3 screws.


c.

Detach the 11 clips.


d.
B240573E02
0.823,4.031 0.594,4.031 false 2.76,4.198 2.76,4.115 2.76,4.115 2.688,4.031 false 0.427,3.948 0.625,4.146 0.198,0.198 10 false *1 2.677,4.229 2.875,4.427 0.198,0.198 10 false *1

Pull out the front door trim board sub-assembly in the direction indicated by the arrow as shown in the illustration.

Text in Illustration
*1 Reference Boss


e.

Raise the front door trim board sub-assembly to detach the 4 claws and remove the front door trim board sub-assembly together with the front door inner glass weatherstrip LH.


f.
B240574

Disconnect the connector.


g.
B238525

Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.


Hide 68172A 5.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

a.
B238526

Using a screwdriver, detach the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.


Hide 81230 6.REMOVE FRONT DOOR COURTESY LIGHT ASSEMBLY LH

Hide 84040 7.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for Driver Side)

Hide 84930 8.REMOVE DOOR CONTROL SWITCH ASSEMBLY (for Front Passenger Side)

Hide 84810 9.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Front Passenger Side)

Hide 86160 10.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

Hide 89860A 11.REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH

Hide 67832 12.REMOVE FRONT DOOR SERVICE HOLE COVER LH

a.
B240582

Remove the bolt.


b.

Detach the 2 clamps, move the wire harness out of the way and remove the service hole cover.

HINT:

Remove any remaining butyl tape from the door.



Hide 87940 13.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Hide 68102 14.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

a.

Connect the cable to the negative (-) battery terminal.


b.

Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.


c.

Disconnect the cable from the negative (-) battery terminal and power window regulator master switch assembly.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



d.
B240583

Remove the 2 bolts.

NOTICE:

Be careful when removing the bolts as the glass may fall and become damaged.



e.
B240584E02
0.417,0.313 0.646,0.542 0.229,0.229 10 true (1) 2.104,0.083 2.313,0.292 0.208,0.208 10 false (2)

Remove the front door glass sub-assembly as indicated by the arrows in the order shown in the illustration.

NOTICE:

Do not damage the door glass.



Hide 69802 15.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

a.
B240585E01
1.672,1.115 1.946,1.409 0.274,0.294 1.712,1.129 1.883,1.312 0.171,0.183 10 *1 1.87,1.219 1.996,1.219 1.996,1.219 2.088,1.277 false

Disconnect the connector.


b.

Loosen the temporary bolt.

Text in Illustration
*1 Temporary Bolt

NOTICE:

Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator may fall and cause damage.



c.

Remove the 5 bolts.


d.

Remove the front door window regulator sub-assembly.


e.

Remove the temporary bolt from the front door window regulator sub-assembly.


Hide 85720C 16.REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

Hide 68151E 17.REMOVE FRONT DOOR GLASS RUN LH

a.
B240586

Remove the front door glass run.


Hide 67664C 18.REMOVE DOOR FRAME GARNISH LH

a.
B240607

Detach the clip and remove the door frame garnish.


Hide 67404F 19.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

a.
B240587

Remove the bolt and front door rear lower frame sub-assembly as shown in the illustration.


Hide 20.REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

a.
B240588

Remove the hole plug.


b.
B240589

Using a T30 "TORX" socket wrench, loosen the screw and remove the front door outside handle cover with lock cylinder assembly.

HINT:

The screw cannot be removed because it is integrated into the front door outside handle frame sub-assembly.



Hide 69217F 21.REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH (for Driver Side)

a.
B238539

Using a screwdriver, detach the claw and remove the front door outside handle cover.


Hide 69217E 22.REMOVE FRONT DOOR OUTSIDE HANDLE COVER RH (for Front Passenger Side)

a.
B240590

Remove the hole plug.


b.
B240591

Using a T30 "TORX" socket wrench, loosen the screw and remove the front door outside handle cover.

HINT:

The screw cannot be removed because it is integrated into the front door outside handle frame sub-assembly.



Hide 69220 23.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B240593

Move the lever in the direction indicated by the arrow in the illustration.


b.
B240594

Remove the front door outside handle assembly as shown in the illustration.


Hide 69241H 24.REMOVE FRONT DOOR FRONT OUTSIDE HANDLE PAD LH

a.
B240595

Detach the 3 claws and remove the front door front outside handle pad.


Hide 69242F 25.REMOVE FRONT DOOR REAR OUTSIDE HANDLE PAD LH

a.
B240595

Detach the 2 claws and remove the front door rear outside handle pad.


Hide 69040A 26.REMOVE FRONT DOOR LOCK ASSEMBLY LH

Hide 69720B 27.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

a.
B240599

Remove the front door lock remote control cable assembly.


Hide 69760C 28.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

a.
B240600

Using a screwdriver, detach the 3 claws.

HINT:

Tape the screwdriver tip before use.



b.
B240601

Remove the front door inside locking cable assembly.


Hide 69202A 29.REMOVE FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH

a.
B240604

Using a T30 "TORX" socket wrench, loosen the screw.


b.

Slide the front door outside handle frame sub-assembly to detach the door handle nut and claw of the front door outside handle frame sub-assembly. Then remove the front door outside handle frame.


Hide 69312 30.REMOVE FRONT DOOR LOCK OPEN ROD LH

a.
B238554E02
2.927,2.458 3.198,2.74 0.271,0.281 10 false (2) 2.49,1.927 2.76,2.094 0.271,0.167 10 true (1)

Remove the front door lock open rod as indicated by the arrows in the order shown in the illustration.


Hide 67924 31.REMOVE FRONT DOOR NO. 2 STIFFENER CUSHION

a.
B238555E03
2.365,1.135 2.125,1.135 2.125,1.135 1.74,0.708 true 2.396,1.063 2.604,1.26 0.208,0.198 10 false *1

Remove the 2 bolts.

Text in Illustration
*1 Double-sided Tape


b.

Detach the 2 claws and remove the front door No. 2 stiffener cushion.


Hide 68620 32.REMOVE FRONT DOOR CHECK ASSEMBLY LH

a.
B238556

Remove the bolt, 2 nuts and front door check assembly.


Hide 67862 33.REMOVE FRONT DOOR WEATHERSTRIP LH

a.
B240608

Using a clip remover, detach the 21 clips and remove the front door weatherstrip.


Hide 75756C 35.REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH

Hide 75976G 38.REMOVE FRONT DOOR LOWER OUTSIDE STRIPE LH

Hide 67001A 39.REMOVE FRONT DOOR PANEL CUSHION

a.
B240615

Using a clip remover, detach the clip and remove the door panel cushion.