Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM1440E _58 Vehicle Interior _056155 DOOR LOCK _0274060 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 69780B 1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 69740D 2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

Hide 69060A 3.INSTALL REAR DOOR LOCK ASSEMBLY LH

NOTICE:
·

When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water to enter into the connection. This may result in a malfunction of the rear door lock assembly.



a.

Apply MP grease to the sliding parts of the rear door lock assembly.


b.

Install a new door lock wiring harness seal to the rear door lock assembly.


c.
B239751

Insert the rear door lock assembly into the rear door outside handle release plate, and set it in place on the rear door panel.


d.

Check that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.


e.

Using a T30 "TORX" wrench, install the rear door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 68104 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 68124C 5.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 67408F 6.INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

Hide 68152C 7.INSTALL REAR DOOR GLASS RUN LH

Hide 67842E 8.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 68174A 9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

Hide 67604 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 69278C 11.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).