Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
69278C
2.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH
67604
3.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
68174A
4.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
67842E
5.REMOVE REAR DOOR SERVICE HOLE COVER LH
68152C
6.REMOVE REAR DOOR GLASS RUN LH
67408F
7.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
68124C
8.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
68104
9.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
69060A
10.REMOVE REAR DOOR LOCK ASSEMBLY LH
Using a T30 "TORX" wrench, remove the 3 screws.
Move the rear door lock assembly downward, pull the release plate out of the rear door outside handle frame, and remove the rear door lock assembly and cables as a unit.
Remove the door lock wiring harness seal from the rear door lock assembly.
69740D
11.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
69780B
12.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH