Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM
RM1440E _58 Vehicle Interior _056155 DOOR LOCK _0274065 KEY REMINDER WARNING SYSTEM U

DOOR LOCK  KEY REMINDER WARNING SYSTEM  TERMINALS OF ECU  


CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)


U149717E06
1.604,1.531 1.844,1.281 1.844,1.281 1.927,1.281 true 1.604,1.854 1.844,1.615 1.844,1.615 1.927,1.615 true 1.615,2.208 1.854,1.969 1.854,1.969 1.938,1.969 true 0.906,1.583 1.094,1.75 0.188,0.167 10 false 2F 1.083,3.875 1.365,4.031 0.281,0.156 10 false F10 0.906,2.167 1.094,2.323 0.188,0.156 10 false 2D 5.854,1.542 6.063,1.698 0.208,0.156 10 false 2B 5.844,2.188 6.052,2.344 0.208,0.156 10 false 2C 1.063,2.76 1.271,2.917 0.208,0.156 10 false 2E 3.75,1.365 3.865,1.51 0.115,0.146 10 false A 1.99,1.219 2.26,1.365 0.271,0.146 10 false F8 1.969,1.563 2.24,1.708 0.271,0.146 10 false F9 1.979,1.896 2.25,2.042 0.271,0.146 10 false F10 3.625,3.865 3.823,4.021 0.198,0.156 10 false F9 1.135,5.177 1.354,5.333 0.219,0.156 10 false 2F 1.865,6.406 2.083,6.563 0.219,0.156 10 false 2B 4.938,6.417 5.156,6.573 0.219,0.156 10 false 2C 3.49,7.677 3.625,7.833 0.135,0.156 10 false A 3.938,5.188 4.135,5.344 0.198,0.156 10 false 2D 5.875,5.177 6.073,5.333 0.198,0.156 10 false 2E 5.927,3.865 6.125,4.021 0.198,0.156 10 false F8

a.

Remove the main body ECU (multiplex network body ECU) (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
A-30 (BECU) - Body ground - Battery power supply Always 11 to 14 V
A-31 (ALTB) - Body ground - Battery power supply Always 11 to 14 V
A-32 (IG) - Body ground - Ignition switch power supply Ignition switch ON 11 to 14 V
A-32 (IG) - Body ground - Ignition switch power supply Ignition switch off Below 1 V
A-29 (ACC) - Body ground - ACC power supply Ignition switch ACC 11 to 14 V
A-29 (ACC) - Body ground - ACC power supply Ignition switch off Below 1 V
A-11 (GND1) - Body ground - Ground Always Below 1 Ω
F10-3 (GND2) - Body ground W-B - Body ground Ground Always Below 1 Ω
F9-17 (KSW) - Body ground B - Body ground Unlock warning switch input No key in ignition key cylinder 10 kΩ or higher
F9-17 (KSW) - Body ground B - Body ground Unlock warning switch input Key inserted in ignition key cylinder Below 1 Ω

If the result is not as specified, there may be a malfunction in the wire harness.


c.

Install the main body ECU (multiplex network body ECU).


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
2F-27 (FLCY) - Body ground R - Body ground Front door LH courtesy switch input Front door LH open Below 1 V
2F-27 (FLCY) - Body ground R - Body ground Front door LH courtesy switch input Front door LH closed 11 to 14 V

If the result is not as specified, the main body ECU (multiplex network body ECU) or driver side junction block assembly may have a malfunction.