This circuit provides power to operate the transponder key ECU assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the F34 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F34-1 (+B) - Body ground | Always | 11 to 14 V |
| F34-2 (IG) - Body ground | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F34-16 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Transponder Key ECU Assembly) |
OK
(See pageVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>PROBLEM SYMPTOMS TABLE)
NG