THEFT DETERRENT / KEYLESS ENTRY
ENGINE IMMOBILISER SYSTEM
- PARTS LOCATION2009.08–2013.08from 2013.08
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING2009.08–2013.08from 2013.08
- PROBLEM SYMPTOMS TABLE2009.08–2013.08from 2013.08
- TERMINALS OF ECU
- DTC CHECK / CLEAR
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- B279C An ECM for vehicles without an engine immobiliser system is installed to a vehicle with an engine immobiliser...
- B279A The communication line (EFIO-IMI) between the ECM and transponder key ECU assembly is stuck on HI output for...
- B2797 2 or more ignition keys are positioned too close to each other or noise occurs in the communication line.
- B2780 The unlock warning switch assembly is not detected as being on when the ignition switch is ON.
- B2784 The antenna coil is open/shorted.
- B2799 One of the following conditions is met: · An error in communication between the ECM and transponder key ECU...
- B2796, B2798
- B2793, B2794, B2795
- Security Indicator Light Circuit2009.08–2013.08from 2013.08
- ECU Power Source Circuit
THEFT DETERRENT SYSTEM
- PRECAUTION
- PARTS LOCATION2009.08–2010.082010.08–2013.08from 2013.08
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING2009.08–2013.08from 2013.08
- PROBLEM SYMPTOMS TABLE2009.08–2013.08from 2013.08
- TERMINALS OF ECU2009.08–2013.08from 2013.08
- DATA LIST / ACTIVE TEST
- Engine Hood Courtesy Switch Circuit
- Horn Circuit
- Security Horn Circuit
- Security Indicator Light Circuit2009.08–2013.08from 2013.08
ENGINE HOOD COURTESY SWITCH
- COMPONENTS2009.08–2010.082010.08–2013.08from 2013.08
- REMOVAL2009.08–2010.082010.08–2013.08from 2013.08
- INSPECTION
- INSTALLATION2009.08–2010.082010.08–2013.08from 2013.08