Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM
RM1440E _58 Vehicle Interior _056156 THEFT DETERRENT / KEYLESS ENTRY _0274066 ENGINE IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  B2797  Communication Malfunction No. 1  


DESCRIPTION

This DTC is stored when a communication error occurs between the transponder key amplifier and transponder key ECU assembly. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, or 2) noise is occurring in the communication line.

DTC Code DTC Detection Condition Trouble Area
B2797 2 or more ignition keys are positioned too close to each other or noise occurs in the communication line.
·

Key

·

Harness or connector

·

Transponder key amplifier

·

Transponder key ECU assembly



WIRING DIAGRAM

B168145E09
5.473,1.148 5.949,1.337 0.476,0.189 10 CODE 1.232,1.148 1.708,1.337 0.476,0.189 10 CODE 1.759,1.077 2.433,1.357 0.674,0.280 10 4 5.185,1.074 5.859,1.354 0.674,0.280 10 15 4.852,1.953 5.281,2.139 0.429,0.186 10 F34 4.852,2.107 6.930,2.269 2.078,0.162 10 Transponder Key ECU Assembly 0.555,1.949 0.945,2.107 0.390,0.158 10 F17 0.555,2.11 2.241,2.289 1.686,0.179 10 Transponder Key Amplifier

CAUTION / NOTICE / HINT

NOTICE:

When replacing the transponder key ECU assembly, refer to the Service Bulletin.


PROCEDURE

1.CHECK KEY
a.
B213624

Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether a key ring is in contact with the key grip.

Result
Result Proceed to
Key is near other keys and/or key ring is in contact with key grip A
Key is not near other keys and key ring is not in contact with key grip B



A

2.CHECK FOR DTC

B

3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
2.CHECK FOR DTC
a.

Separate the keys from each other or remove the key ring.



c.

Insert a key into the ignition key cylinder, and then remove it. Repeat this for all the other keys.


d.

Check that no DTC is output (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B2797 is not output.




OK

END

NG

3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
a.

Disconnect the F34 ECU connector.


b.

Disconnect the F17 amplifier connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F34-15 (CODE) - F17-4 (CODE) Always Below 1 Ω
F34-15 (CODE) or F17-4 (CODE) - Body ground Always 10 kΩ or higher




OK

4.CHECK TRANSPONDER KEY ECU ASSEMBLY (NOISE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK TRANSPONDER KEY ECU ASSEMBLY (NOISE)
a.

Using an oscilloscope, check for noise in the waveform between the terminals of the F17 amplifier connector and F34 ECU connector.

B453109E01
0.979,0.667 1.396,0.917 0.417,0.25 3.25,0.667 3.667,0.917 0.417,0.25 6.073,1.25 6.365,0.594 6.365,0.594 6.563,0.594 false 0.875,2.167 1.167,1.406 true 2.698,2.177 2.938,1.458 true 1.052,0.708 1.51,0.906 0.458,0.198 10 false F17 3.313,0.698 3.771,0.896 0.458,0.198 10 false F34 0.271,0.25 0.583,0.448 0.313,0.198 10 false *a 2.417,0.25 2.729,0.448 0.313,0.198 10 false *b 6.604,0.5 6.917,0.698 0.313,0.198 10 false *c 0.552,2.188 1.167,2.385 0.615,0.198 10 false CODE 2.406,2.208 3.021,2.406 0.615,0.198 10 false CODE

Measurement Condition
Item Content
Tester Connection F17-4 (CODE) - F34-15 (CODE)
Tool Setting 5 V/DIV., 20 ms./DIV.
Condition Key inserted in ignition key cylinder

OK:

No noise is present.


Text in Illustration
*a Component with harness connected
(Transponder Key Amplifier)
*b Component with harness connected
(Transponder Key ECU Assembly)
*c Noise should not appear



OK

5.REPLACE TRANSPONDER KEY AMPLIFIER

NG

FIND CAUSE OF NOISE AND REMOVE IT

5.REPLACE TRANSPONDER KEY AMPLIFIER
a.

Temporarily replace the transponder key amplifier with a new or normally functioning one (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>TRANSPONDER KEY AMPLIFIER>REMOVAL).



NEXT

6.CHECK WHETHER ENGINE STARTS
6.CHECK WHETHER ENGINE STARTS
a.

Check that the engine starts normally.

OK:

Engine starts.




OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)

NG

REPLACE TRANSPONDER KEY ECU ASSEMBLY