Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM
RM1440E _58 Vehicle Interior _056156 THEFT DETERRENT / KEYLESS ENTRY _0274066 ENGINE IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  B2780  Push Switch / Key Unlock Warning Switch Malfunction  


DESCRIPTION

This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON. Under normal conditions, the unlock warning switch assembly is on when the ignition switch is ON.

DTC Code DTC Detection Condition Trouble Area
B2780 The unlock warning switch assembly is not detected as being on when the ignition switch is ON.
·

Transponder key ECU assembly

·

Unlock warning switch assembly

·

Harness or connector



WIRING DIAGRAM

B242195E09
4.543,1.731 6.625,1.897 2.082,0.166 10 Transponder Key ECU Assembly 1.212,1.478 3.354,1.659 2.141,0.182 10 Unlock Warning Switch Assembly 1.212,1.307 1.540,1.503 0.328,0.197 10 F18 4.469,0.796 4.599,0.950 0.130,0.155 10 3 4.541,1.549 4.820,1.704 0.279,0.155 10 F34 4.695,0.903 5.105,1.058 0.410,0.155 10 KSW 1.409,0.806 1.520,0.961 0.110,0.155 10 2 2.852,0.795 2.963,0.950 0.110,0.155 10 1

CAUTION / NOTICE / HINT

NOTICE:

When replacing the transponder key ECU assembly, refer to the Service Bulletin.


PROCEDURE

1.CLEAR DTC

NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

OK

NG

3.INSPECT UNLOCK WARNING SWITCH ASSEMBLY
3.INSPECT UNLOCK WARNING SWITCH ASSEMBLY
a.
E198930

Remove the unlock warning switch assembly (See page Vehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 Pushed Below 1 Ω
Not pushed 10 kΩ or higher




OK

4.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU AND BODY GROUND)

NG

REPLACE UNLOCK WARNING SWITCH ASSEMBLY

4.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU AND BODY GROUND)
a.

Disconnect the F18 switch connector.


b.

Disconnect the F34 ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F34-3 (KSW) - F18-1 Always Below 1 Ω
F34-3 (KSW) or F18-1 - Body ground Always 10 kΩ or higher
F18-2 - Body ground Always Below 1 Ω




OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR