Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM
RM1440E _58 Vehicle Interior _056157 LIGHTING (INT) _0274081 LIGHTING SYSTEM J

LIGHTING (INT)  LIGHTING SYSTEM  Luggage Room Light Circuit  


DESCRIPTION

The multiplex network door ECU controls the spot light.

WIRING DIAGRAM

E200971E03
4.51,4.875 6.375,5.073 1.865,0.198 10 false Multiplex Network Door ECU 4.583,1.052 4.896,1.24 0.313,0.188 10 false W10 4.583,1.552 4.896,1.729 0.313,0.177 10 false W10 4.583,2.042 4.896,2.198 0.313,0.156 10 false W10 4.573,3.229 4.875,3.427 0.302,0.198 10 false W10 4.563,3.729 4.885,3.896 0.323,0.167 10 false W10 4.563,4.229 4.875,4.396 0.313,0.167 10 false W10 0.906,2.51 2.49,2.708 1.583,0.198 10 false Spot Light Assembly LH 0.906,2.354 1.271,2.542 0.365,0.188 10 false W12 0.906,4.677 2.51,4.875 1.604,0.198 10 false Spot Light Assembly RH 0.906,4.521 1.271,4.708 0.365,0.188 10 false W7 4.938,0.938 5.167,1.104 0.229,0.167 10 false B2 2.135,3.208 2.354,3.375 0.219,0.167 10 false B 2.417,3.115 2.563,3.281 0.146,0.167 10 false 1 2.135,4.208 2.354,4.375 0.219,0.167 10 false E 2.427,4.115 2.646,4.281 0.219,0.167 10 false 2 1.948,3.698 2.313,3.865 0.365,0.167 10 false CTY 2.427,3.604 2.646,3.771 0.219,0.167 10 false 3 2.135,1.052 2.271,1.219 0.135,0.167 10 false B 2.427,0.917 2.552,1.083 0.125,0.167 10 false 1 2.135,2.042 2.281,2.208 0.146,0.167 10 false E 2.427,1.917 2.573,2.083 0.146,0.167 10 false 2 1.948,1.552 2.26,1.719 0.313,0.167 10 false CTY 2.427,1.417 2.573,1.583 0.146,0.167 10 false 3 4.646,0.854 4.865,1.021 0.219,0.167 10 false 25 4.938,0.375 5.198,0.552 0.26,0.177 10 false B1 4.646,0.49 4.865,0.667 0.219,0.177 10 false V2 4.646,0.302 4.865,0.469 0.219,0.167 10 false 17 4.948,1.542 5.333,1.729 0.385,0.188 10 false LGLP 3.979,0.625 4.448,0.813 0.469,0.188 10 false DOME 4.646,1.344 4.865,1.51 0.219,0.167 10 false 22 4.938,1.948 5.156,2.104 0.219,0.156 10 false E1 4.625,1.844 4.844,2.01 0.219,0.167 10 false 19 4.948,3.125 5.188,3.302 0.24,0.177 10 false B3 4.656,3.031 4.875,3.198 0.219,0.167 10 false 26 4.958,3.719 5.438,3.906 0.479,0.188 10 false LGP2 4.667,3.521 4.885,3.688 0.219,0.167 10 false 23 4.958,4.115 5.438,4.302 0.479,0.188 10 false E2 4.667,4.031 4.885,4.198 0.219,0.167 10 false 20 2.583,0.479 3.406,0.667 0.823,0.188 10 false from Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SPOT LIGHT)
a.

Using the intelligent tester, perform the Active Test (See page Vehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST).

Back Door
Tester Display Test Part Control Range Diagnostic Note
Luggage Compartment Light Spot light ON/OFF -

OK:

Spot light comes on.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (BATTERY - MULTIPLEX NETWORK DOOR ECU)
2.CHECK HARNESS AND CONNECTOR (BATTERY - MULTIPLEX NETWORK DOOR ECU)
a.

Disconnect the V2 multiplex network door ECU connector.


U150526E03
1.26,1.385 0.896,1.385 true 0.646,1.302 0.875,1.49 0.229,0.188 10 false B1 0.219,0.104 0.448,0.292 0.229,0.188 10 false *a 1.604,0.417 1.833,0.604 0.229,0.188 10 false V2

b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
V2-17 (B1) - Body ground Always 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Multiplex Network Door ECU)



OK

3.CHECK HARNESS AND CONNECTOR (SPOT LIGHT ASSEMBLY - MULTIPLEX NETWORK DOOR ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (SPOT LIGHT ASSEMBLY - MULTIPLEX NETWORK DOOR ECU)
a.

Disconnect the W12*1 or W7*2 spot light connector.

*1: for LH

*2: for RH



b.

Disconnect the W10 multiplex network door ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LH:
Tester Connection Condition Specified Condition
W12-1 (B) - W10-25 (B2) Always Below 1 Ω
W12-3 (CTY) - W10-22 (LGLP) Always Below 1 Ω
W12-2 (E) - W10-19 (E1) Always Below 1 Ω
W12-1 (B) - Body ground Always 10 kΩ or higher
W12-3 (CTY) - Body ground Always 10 kΩ or higher
W12-2 (E) - Body ground Always 10 kΩ or higher

for RH:
Tester Connection Condition Specified Condition
W7-1 (B) - W10-26 (B3) Always Below 1 Ω
W7-3 (CTY) - W10-23 (LGP2) Always Below 1 Ω
W7-2 (E) - W10-20 (E2) Always Below 1 Ω
W7-1 (B) - Body ground Always 10 kΩ or higher
W7-3 (CTY) - Body ground Always 10 kΩ or higher
W7-2 (E) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR