83100
1.INSTALL COMBINATION METER ASSEMBLY
Connect the connectors.
Install the combination meter with the 4 screws.
55404D
2.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Attach the 7 claws to install the finish panel.
Attach the 4 claws.
55480D
3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55447C
4.INSTALL NO. 2 SWITCH HOLE BASE
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).