Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER
RM1440E _58 Vehicle Interior _056158 METER / GAUGE / DISPLAY _0274085 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55480D 3.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55404D 4.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.

Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.


b.
E196438E01
2.878,1.196 3.182,0.972 false 3.228,0.852 3.379,1.022 0.151,0.170 10 *1

Place protective tape as shown in the illustration.

Text in Illustration
*1 Protective Tape


c.

Detach the 4 claws.


d.
E196439

Detach the 7 clips and remove the finish panel.


Hide 83100 5.REMOVE COMBINATION METER ASSEMBLY

a.
E196440

Remove the 4 screws.


b.

Disconnect the connectors, and remove the combination meter by pulling it up in the direction of the arrow in the illustration.