Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM1440E _58 Vehicle Interior _056160 SUPPLEMENTAL RESTRAINT SYSTEMS _0274091 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  INSTALLATION  


PROCEDURE

Hide 84306 1.INSTALL SPIRAL CABLE SUB-ASSEMBLY

a.

Attach the 3 claws to install the spiral cable.

CAUTION:

When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.



b.

Connect the connectors to the spiral cable.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 45286B 2.INSTALL UPPER STEERING COLUMN COVER

Hide 45287 3.INSTALL LOWER STEERING COLUMN COVER

Hide 84306 4.ADJUST SPIRAL CABLE SUB-ASSEMBLY

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



c.
B181594

Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

CAUTION:

Do not turn the spiral cable by the airbag wire harness.



d.
B181595E03
1.563,1.775 1.889,1.957 0.326,0.181 10 *1 0.644,1.519 1.29,1.86 false 1.29,1.86 1.556,1.86 false

Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

Text in Illustration
*1 Mark

CAUTION:

Do not turn the spiral cable by the airbag wire harness.


HINT:

The spiral cable can be rotated approximately 2.5 turns to both the left and right from the center position.



Hide 45100 5.INSTALL STEERING WHEEL ASSEMBLY

a.

Install the steering wheel assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>INSTALLATION).