Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM1440E _58 Vehicle Interior _056160 SUPPLEMENTAL RESTRAINT SYSTEMS _0274091 SPIRAL CABLE G

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  INSPECTION  


PROCEDURE

Hide 84306 1.INSPECT SPIRAL CABLE SUB-ASSEMBLY

a.

If there are any defects as mentioned below, replace the spiral cable with a new one:

Scratches, cracks, dents or chips in the connector or spiral cable.


b.

Check the spiral cable.

C361821E01
1.688,1.281 2.146,1.479 0.458,0.198 10 false z12 2.271,2.167 2.729,2.365 0.458,0.198 10 false z13 4.708,0.948 5.167,1.146 0.458,0.198 10 false z11 5.219,0.958 5.677,1.156 0.458,0.198 10 false z9 4.698,3.25 5.156,3.448 0.458,0.198 10 false F23 5.438,3.292 5.896,3.49 0.458,0.198 10 false F24 2,0.896 2.313,1.094 0.313,0.198 10 false *a 2.625,1.375 2.938,1.573 0.313,0.198 10 false *b

Text in Illustration
*a Orange
*b Black

i.

Set the spiral cable to the center position (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSTALLATION).


ii.

After setting the spiral cable to the center position, rotate the spiral cable 2.5 times clockwise and measure the resistance according to the value(s) in the table below. Then rotate the spiral cable 5 times counterclockwise and measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F24-1 - z12-2 Always Below 1 Ω
F24-2 - z12-1 Always Below 1 Ω
F24-3 - z13-2 Always Below 1 Ω
F24-4 - z13-1 Always Below 1 Ω
F23-6 - z11-10 Always Below 1 Ω
F23-5 - z11-9 Always Below 1 Ω
F23-4 - z11-8 Always Below 1 Ω
F23-3 - z11-7 Always Below 1 Ω
F23-2 - z11-6 Always Below 1 Ω
F23-1 - z9-4 Always Below 1 Ω
F23-12 - z11-5 Always Below 1 Ω
F23-11 - z11-4 Always Below 1 Ω
F23-10 - z11-3 Always Below 1 Ω
F23-9 - z11-2 Always Below 1 Ω
F23-8 - z11-1 Always Below 1 Ω
F23-7 - z9-1 Always Below 1 Ω



iii.

After setting the spiral cable to the center position, rotate the spiral cable 2.5 times clockwise. Then, while rotating the spiral cable 5 times counterclockwise, measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F24-1 - z12-2 Always Below 1 Ω
F24-2 - z12-1 Always Below 1 Ω
F24-3 - z13-2 Always Below 1 Ω
F24-4 - z13-1 Always Below 1 Ω
F23-6 - z11-10 Always Below 1 Ω
F23-5 - z11-9 Always Below 1 Ω
F23-4 - z11-8 Always Below 1 Ω
F23-3 - z11-7 Always Below 1 Ω
F23-2 - z11-6 Always Below 1 Ω
F23-1 - z9-4 Always Below 1 Ω
F23-12 - z11-5 Always Below 1 Ω
F23-11 - z11-4 Always Below 1 Ω
F23-10 - z11-3 Always Below 1 Ω
F23-9 - z11-2 Always Below 1 Ω
F23-8 - z11-1 Always Below 1 Ω
F23-7 - z9-1 Always Below 1 Ω


NOTICE:

As the spiral cable may break, do not rotate the spiral cable more than the specified amount.