Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM1440E _58 Vehicle Interior _056160 SUPPLEMENTAL RESTRAINT SYSTEMS _0274091 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 45100 1.REMOVE STEERING WHEEL ASSEMBLY

a.

Remove the steering wheel assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).


Hide 45287 2.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 3.REMOVE UPPER STEERING COLUMN COVER

Hide 84306 4.REMOVE SPIRAL CABLE SUB-ASSEMBLY

a.
B240150

Disconnect the connectors from the spiral cable.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Detach the 3 claws and remove the spiral cable.

NOTICE:
·

Do not replace the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.

·

Do not rotate the spiral cable when the ignition switch is ON and the battery cable is connected.

·

Make sure the steering wheel is installed and centered before rotating the steering angle sensor when performing steering angle sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).

·

Do not remove the steering angle sensor from the spiral cable.