Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
63310
1.REMOVE ROOF HEADLINING ASSEMBLY
62180A
2.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/o Rear No. 2 Seat)
Using a screw driver, release the airbag connector lock and disconnect the curtain shield airbag connector.
| *1 | Curtain Shield Airbag Connector |
| *2 | Airbag Connector Lock |
| *3 | Protective Tape |
When handling the curtain shield airbag connector, take care not to damage the airbag wire harness.
Tape the screwdriver tip before use.
Remove the 11 bolts and curtain shield airbag assembly LH.
62180A
3.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/ Rear No. 2 Seat)
Using a screw driver, release the airbag connector lock and disconnect the curtain shield airbag connector.
| *1 | Curtain Shield Airbag Connector |
| *2 | Airbag Connector Lock |
| *3 | Protective Tape |
When handling the curtain shield airbag connector, take care not to damage the airbag wire harness.
Tape the screwdriver tip before use.
Remove the 13 bolts and curtain shield airbag assembly LH.