Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
If the side airbag was deployed, replace the separate type front seatback assembly with the necessary parts in accordance with the extent of the collision damage.
71100S
2.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
71100S
3.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
4.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)
Remove the rubber band from the seat cushion spring.
Detach the claw and disconnect the airbag connector.
Detach the 3 airbag wire harness clamps.
Detach the fastening tape and open the cover.
| *1 | Fastening Tape |
Disconnect the airbag wire harness.
Remove the 3 hog rings.
Open the 2 fasteners, and then open the seatback cover.
Remove the nut and seatback cover bracket from the seat frame.
Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.
Remove the separate type front seatback cover with pad from the seat frame.
5.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)
Remove the rubber band from the seat cushion spring.
Detach the claw and disconnect the airbag connector.
Detach the 3 airbag wire harness clamps.
Detach the fastening tape and open the cover.
| *1 | Fastening Tape |
Disconnect the airbag wire harness.
Remove the 3 hog rings.
| *1 | Hog Ring |
| *2 | Clamp |
w/ Seat Heater System:
Disconnect the seat heater connector and detach the seat heater wire harness clamp.
Open the 2 fasteners, and then open the seatback cover.
| *A | for Cloth Seat | *B | for Leather Seat |
Remove the nut and seatback cover bracket from the seat frame.
Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.
Remove the separate type front seatback cover with pad from the seat frame.
6.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY
Detach the 2 clamps and disconnect the wire harness.
Remove the 2 nuts and front seat side airbag assembly.
The nuts must not be reused.
Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.