Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67492A
2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69298A
3.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
67602
4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
5.REMOVE FRONT DOOR GLASS WEATHERSTRIP INNER LH
89860A
6.REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH
Disconnect the connector.
Remove the bolt and side airbag sensor.