Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
62476E
1.REMOVE REAR SEAT CAP
Remove the 2 caps.
71694
2.REMOVE REAR SEAT LOWER CUSHION HINGE COVER LH
Remove the 2 screws.
Detach the 3 claws and remove the cover.
71693
3.REMOVE REAR SEAT LOWER CUSHION HINGE COVER RH
Remove the 2 screws.
| *1 | Guide |
Detach the 2 claws and guide and remove the cover.
73590
4.REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY LH
71827B
5.REMOVE REAR NO. 1 SEAT CUSHION MOULDING
Using a clip remover, remove the 2 clips.
| *1 | Guide |
Detach the 2 claws and 4 guides and remove the moulding.
6.REMOVE SEAT CUSHION COVER WITH PAD
Detach the 2 fasteners.
| *1 | Fastener |
Open the 2 fasteners.
| *1 | Fastener |
Using a clip remover, remove the 2 clips and open the under part of the seat cushion cover.
Detach the 2 hooks.
| *1 | Hook |
Detach the 2 hooks and remove the seat cushion cover with pad.
| *1 | Hook |
79031
7.REMOVE NO. 3 SEAT CUSHION COVER SUB-ASSEMBLY LH
Detach the fastener.
| *1 | Fastener |
Remove the hog rings and seat cushion cover.
71537B
8.REMOVE REAR NO. 2 SEAT CUSHION PROTECTOR
Cut off the tack pins and remove the protector from the seat cushion pad.
| *1 | Tack Pin |
71827B
9.REMOVE REAR NO. 2 SEAT CUSHION MOULDING
Remove the 2 screws.
Detach the 2 claws and remove the moulding.
79202
10.REMOVE NO. 2 SEAT CUSHION FRAME SUB-ASSEMBLY LH
Operate the seat track lock lever and retract the seat cushion frame.
Using a T40 "TORX" socket wrench, remove the 4 "TORX" bolts and seat cushion frame.
72906
11.REMOVE 3RD SEAT LINK SUB-ASSEMBLY LH
Remove the 3 clips.
| *1 | Guide |
Detach the 2 claws and 4 guides and remove the 3rd seat link.
72241B
12.REMOVE SEAT TRACK LOCK LEVER
Detach the clamp.
| *1 | Cable End |
| *2 | Clamp |
Twist the cable end in the direction indicated by the arrow and disconnect the cable.
Remove the screw.
| *1 | Guide |
Detach the 2 guides and remove the lever.
79384
13.REMOVE REAR SEAT LEG COVER LH
Remove the clip.
| *1 | Hook |
Detach the 3 hooks and 5 clips and remove the cover.
79384A
14.REMOVE REAR NO. 3 SEAT LEG COVER LH
Detach the 2 claws and remove the cover.
71693D
15.REMOVE REAR SEAT CUSHION INNER HINGE COVER LH
Remove the screw and clip.
| *1 | Guide |
Detach the guide and remove the cover.
71693D
16.REMOVE REAR SEAT CUSHION INNER HINGE COVER RH
Remove the screw and clip.
| *1 | Guide |
Detach the guide and remove the cover.
72695C
17.REMOVE REAR SEAT LOCK CONTROL CABLE LH
Detach the clamp.
| *1 | Clamp |
| *2 | Cable End |
Twist the cable end in the direction indicated by the arrow and remove the cable.
72615H
18.REMOVE REAR NO. 1 SEATBACK LOCK STRIKER COVER
Using a screwdriver, detach the claw and guide and remove the cover.
Tape the screwdriver tip before use.
| *1 | Guide |
| *2 | Protective Tape |
72058B
19.REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
Remove the 2 screws.
| *1 | Clamp |
| *2 | Cable End |
| *3 | Guide |
Detach the guide and remove the lever.
Detach the clamp.
Twist the cable end in the direction indicated by the arrow and disconnect the cable.
66310F
20.REMOVE ROPE HOOK ASSEMBLY
Using a screwdriver, detach the 2 claws and open the cover.
| *1 | Protective Tape |
Tape the screwdriver tip before use.
Remove the bolt and rope hook.
72615G
21.REMOVE REAR NO. 2 SEATBACK LOCK STRIKER COVER
Using a screwdriver, detach the claw and guide and remove the cover.
Tape the screwdriver tip before use.
| *1 | Guide |
72690
22.REMOVE REAR SEAT LOCK RELEASE LEVER ASSEMBLY
Remove the 2 screws.
| *1 | Hook |
Detach the hook and remove the lever.
Detach the 2 clamps.
| *1 | Cable End |
| *2 | Clamp |
Twist the 2 cable ends in the direction indicated by the arrow and disconnect the 2 cables.
71702C
23.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH
Detach the 7 clips and remove the board.
72635B
24.REMOVE REAR SEATBACK LOCK HOOK
Remove the lock hook.
71865
25.REMOVE REAR SEAT NO. 1 COVER BEZEL
Remove the 2 screws, detach the guide and remove the bezel.
| *1 | Guide |
26.REMOVE SEATBACK COVER WITH PAD
Detach the hooks.
| *1 | Hook |
Detach the 8 clips and remove the seatback cover with pad.
79034
27.REMOVE NO. 3 SEATBACK COVER SUB-ASSEMBLY LH
Remove the hog rings and seatback cover.
71587C
28.REMOVE REAR NO. 2 SEATBACK EDGE PROTECTOR
Cut off the tack pins and remove the protector from the seatback pad.
| *1 | Tack Pin |
71970A
29.REMOVE REAR SEAT HEADREST COVER
Remove the 2 screws.
| *1 | Guide |
Detach the 2 claws and guide and remove the cover.
71987A
30.REMOVE REAR SEAT HEADREST CABLE
Detach the 2 clamps.
| *1 | Cable End |
| *2 | Clamp |
Twist the 2 cable ends in the direction indicated by the arrow and remove the cable.
71970
31.REMOVE REAR SEAT HEADREST ASSEMBLY
Remove the 3 nuts and headrest.
71697B
32.REMOVE REAR NO. 3 SEAT PROTECTOR LH
Detach the 4 claws and remove the 2 protectors.
71844C
33.REMOVE REAR NO. 2 SEAT INNER RECLINING COVER LH
Detach the 4 claws and remove the cover.
71844A
34.REMOVE REAR NO. 2 SEAT OUTER RECLINING COVER LH
Remove the screw.
| *1 | Guide |
Detach the 2 claws and guide and remove the cover.
71833C
35.REMOVE REAR NO. 2 SEAT INNER RECLINING COVER RH
Detach the 5 claws and remove the cover.
71843D
36.REMOVE REAR NO. 2 SEAT OUTER RECLINING COVER RH
Remove the screw.
| *1 | Guide |
Detach the 2 claws and guide and remove the cover.
72690A
37.REMOVE REAR SEAT LOCK RELEASE STRAP ASSEMBLY
Detach the 2 clamps.
| *1 | Cable End |
| *2 | Clamp |
Twist the cable end in the direction indicated by the arrow and remove the cable.
72690A
38.REMOVE REAR SEAT LOCK RELEASE STRAP ASSEMBLY (for RH Side)
Detach the 3 clamps and cut off the 2 cable ties.
| *1 | Cable End |
| *2 | Cable Tie |
| *3 | Clamp |
Twist the cable end in the direction indicated by the arrow and remove the cable.
78091
39.REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY
Remove the clamp labeled B and detach the 2 clamps labeled A.
| *1 | Clamp A |
| *2 | Clamp B |
| *3 | Cable Tie |
| *4 | Cable End |
Cut off the 2 cable ties.
Twist the cable end in the direction indicated by the arrow and remove the cable.
79226
40.REMOVE NO. 2 SEAT LOCK CABLE
Detach the clamp.
| *1 | Clamp |
| *2 | Cable End |
Twist the cable end in the direction indicated by the arrow and remove the cable.
79304A
41.REMOVE NO. 3 SEATBACK FRAME SUB-ASSEMBLY LH
Using a T45 "TORX" socket wrench, remove the 4 "TORX" bolts and frame.
79040
42.REMOVE NO. 3 SEAT LEG ASSEMBLY LH
Remove the 4 clips and seat cushion under carpet LH from the No. 3 seat leg.