Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
72526
1.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the handle.
Tape the screwdriver tip before use.
| *1 | Protective Tape |
72495
2.REMOVE VERTICAL ADJUSTING HANDLE LH (for Driver Side)
Remove the screw and handle.
71812D
3.REMOVE FRONT SEAT CUSHION SHIELD LH
Remove the screw.
Using a moulding remover, detach the 4 claws and clip, and then remove the cushion shield.
for Driver Side:
Detach the 5 wire harness clamps and disconnect the 2 connectors.
84920
4.REMOVE LUMBAR SWITCH ASSEMBLY (for Driver Side)
71862
5.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
Using a moulding remover, detach the 3 claws and remove the cushion shield.
71861
6.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
Using a moulding remover, detach the 4 claws and remove the cushion shield.
73240
7.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
71440S
8.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Remove the rubber band from the seat cushion spring.
for Driver Side:
Detach the clamp and disconnect the No. 2 seat wire.
Using a clip remover, remove the 2 clips.
Detach the claw and disconnect the airbag connector.
Detach the 3 airbag wire harness clamps.
Detach the fastening tape and open the cover.
| *1 | Fastening Tape |
Disconnect the airbag wire harness.
Remove the 4 bolts and seatback assembly.
71849
9.REMOVE SEAT ADJUSTER COVER CAP
Remove the 2 caps.
71149A
10.REMOVE FRONT SEAT LEG COVER LH
Detach the 2 claws.
Move the cover in the direction of the arrow to remove the cover.
11.REMOVE SEAT CUSHION COVER WITH PAD
Detach the hooks.
for Front Passenger Side:
Detach the claw and disconnect the connector.
Remove the seat cushion cover with pad.
71072S
12.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the hog rings and seat cushion cover from the seat cushion pad.
71876
13.REMOVE RECLINING ADJUSTER INSIDE COVER LH
Detach the claw and guide, and then remove the cover.
71874A
14.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH
Remove the screw.
Detach the hook and clip, and then remove the cushion shield.
71873B
15.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH
Remove the screw.
Detach the hook and clip, and then remove the cushion shield.
71537D
16.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH
Remove the screw.
Move the protector in the direction of the arrow to detach the hook and remove the protector.
71537C
17.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH
Use the same procedure described for the LH side.
82192
18.REMOVE FRONT SEAT WIRE LH
Remove the seat wire.
71876A
19.REMOVE RECLINING ADJUSTER INSIDE COVER LH
Detach the guide.
Move the cover in the direction of the arrow to remove it.
71875A
20.REMOVE RECLINING ADJUSTER INSIDE COVER RH
Use the same procedure described for the LH side.
71074S
21.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Remove the 3 hog rings.
Open the 2 fasteners, and then open the seatback cover.
Remove the nut and seatback cover bracket from the seat frame.
Disconnect the seatback cover bracket from the seatback pad.
Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.
Remove the hog rings and seatback cover.
71552S
22.REMOVE SEPARATE TYPE FRONT SEATBACK PAD
Remove the seatback pad.
82168
23.REMOVE NO. 2 SEAT WIRE (for Driver Side)
Disconnect the connector.
Detach the 2 clamps and remove the seat wire.
24.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY