Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat) › from 2013.08
RM1440E _58 Vehicle Interior _056161 SEAT _0274104 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).

·

If the side airbag was deployed, replace the separate type front seatback assembly with the necessary parts in accordance with the extent of the collision damage.



Hide 71910A 2.REMOVE FRONT SEAT HEADREST ASSEMBLY

a.

Remove the front seat headrest assembly.


Hide 72128A 3.REMOVE FRONT SEAT INNER TRACK BRACKET COVER LH

a.

Operate the power seat switch (slide switch) to move the front seat assembly to the rearmost position.


b.
B241794

Using a moulding remover, detach the 2 claws.


c.

Move the front seat inner track bracket cover LH in the direction of the arrow to detach the 2 guides and remove the front seat inner track bracket cover LH.


Hide 72124 4.REMOVE FRONT SEAT OUTER TRACK BRACKET COVER LH

a.
B239528

Using a moulding remover, detach the 2 claws.


b.

Move the front seat outer track bracket cover LH in the direction of the arrow to detach the 2 claws and guide, and remove the front seat outer track bracket cover LH.


Hide 72158 5.REMOVE INNER SEAT TRACK BRACKET COVER LH

a.

Operate the power seat switch (slide switch) to move the front seat assembly to the foremost position.


b.
B238099

Using a moulding remover, detach the 2 claws.


c.

Move the inner seat track bracket cover LH in the direction of the arrow to detach the 2 guides and remove the inner seat track bracket cover LH.


Hide 72138 6.REMOVE OUTER SEAT TRACK COVER LH

a.
B238101

Using a moulding remover, detach the 2 claws.


b.

Move the outer seat track cover LH in the direction of the arrow to detach the 4 guides and remove the outer seat track cover LH.


Hide 7.REMOVE FRONT SEAT ASSEMBLY

a.
B238103

Remove the 2 bolts.


b.

Operate the power seat switch (slide switch) to move the front seat assembly to the rearmost position.


c.
B239529

Remove the 2 bolts.


d.

Operate the power seat switch (slide switch) to move the front seat assembly to the center position, and operate the power seat switch (reclining switch) to move the seatback to the upright position.


e.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



f.

Disconnect the connectors under the seat.


g.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.