Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
84921B
1.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Using a moulding remover, detach the 2 claws and remove the knob.
84921A
2.REMOVE RECLINING POWER SEAT SWITCH KNOB
Using a moulding remover, detach the 2 claws and remove the knob.
71812D
3.REMOVE FRONT SEAT CUSHION SHIELD LH
Disconnect the lifter motor connector.
Remove the screw of the front seat No. 1 inner cushion shield and detach the guide.
Detach the clip of the front seat No. 1 inner cushion shield.
Using a moulding remover, detach the 3 claws and guide.
Move the cushion shield in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield together with the cushion shield as a unit.
Detach the 3 claws and open the wire harness cover.
Detach the 3 wire harness clamps and disconnect the seat wire connector.
84922C
4.REMOVE FRONT POWER SEAT SWITCH LH
84920
5.REMOVE LUMBAR SWITCH ASSEMBLY (for Driver Side)
71868A
6.REMOVE FRONT SEAT NO. 1 INNER CUSHION SHIELD LH
Detach the 2 claws and remove the cushion shield.
71862
7.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
Using a moulding remover, detach the 3 claws and remove the cushion shield.
71861
8.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
Using a moulding remover, detach the 4 claws and remove the cushion shield.
73240
9.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
71440S
10.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Remove the rubber band from the seat cushion spring.
Detach the clamp and disconnect the No. 2 seat wire.
w/ Seat Heater System:
Disconnect the seat heater connector and detach the seat heater wire harness clamp.
Detach the 2 hooks.
Detach the claw and disconnect the airbag connector.
Detach the 3 airbag wire harness clamps.
Detach the fastening tape and open the cover.
| *1 | Fastening Tape |
Disconnect the airbag wire harness.
Remove the 4 bolts and seatback assembly.
71849
11.REMOVE SEAT ADJUSTER COVER CAP
Remove the 2 caps.
71149A
12.REMOVE FRONT SEAT LEG COVER LH
Detach the 2 claws.
Move the cover in the direction of the arrow to remove it.
13.REMOVE SEAT CUSHION COVER WITH PAD
w/ Seat Heater System:
Disconnect the seat heater connector and detach the 3 seat heater wire harness clamps.
Detach the hooks.
for Front Passenger Side:
Detach the claw and disconnect the connector.
Remove the seat cushion cover with pad.
71072S
14.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the hog rings and seat cushion cover from the seat cushion pad.
71876
15.REMOVE RECLINING ADJUSTER INSIDE COVER LH
Detach the claw and guide, and then remove the cover.
71874A
16.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH
Remove the screw.
Detach the hook and clip, and then remove the cushion shield.
71873B
17.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH
Remove the screw.
Detach the hook and clip, and then remove the cushion shield.
71537D
18.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH
Remove the screw.
Move the protector in the direction of the arrow to detach the hook and remove the protector.
71537C
19.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH
Use the same procedure described for the LH side.
87501B
20.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)
82192
21.REMOVE FRONT SEAT WIRE LH
Remove the seat wire.
71876A
22.REMOVE RECLINING ADJUSTER INSIDE COVER LH
Detach the guide and remove the cover.
71875A
23.REMOVE RECLINING ADJUSTER INSIDE COVER RH
Detach the guide and remove the cover.
71074S
24.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Remove the 3 hog rings.
Open the 2 fasteners, and then open the seatback cover.
| *A | for Cloth Seat | *B | for Leather Seat |
Remove the nut and seatback cover bracket from the seat frame.
Disconnect the seatback cover bracket from the seatback pad.
Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.
Remove the hog rings and seatback cover.
71552S
25.REMOVE SEPARATE TYPE FRONT SEATBACK PAD
Remove the seatback pad.
82168
26.REMOVE NO. 2 SEAT WIRE
for Driver Side:
Disconnect the 2 connectors.
for Front Passenger Side:
Disconnect the connector.
Detach the 2 clamps and remove the seat wire.
27.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY