Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY
Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL).
84921B
2.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
84921A
3.REMOVE RECLINING POWER SEAT SWITCH KNOB
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD LH
84922C
5.REMOVE FRONT POWER SEAT SWITCH LH
84920
6.REMOVE LUMBAR SWITCH ASSEMBLY (for Driver Side)
71862
7.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
71861
8.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
73240
9.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
10.REMOVE SEAT CUSHION COVER WITH PAD
Remove the rubber band from the seat cushion spring.
Disconnect the seat heater connector and detach the wire harness clamp.
Detach the fastening tape and open the cover.
| *1 | Fastening Tape |
Disconnect the airbag wire harness.
Detach the 2 hooks.
Disconnect the seat heater connector and detach the 3 wire harness clamps.
Detach the hooks.
for Front Passenger Side:
Detach the claw and disconnect the connector.
Remove the seat cushion cover with pad.
71072S
11.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the hog rings and seat cushion cover from the seat cushion pad.