Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM1440E _58 Vehicle Interior _056162 SEAT BELT _0274124 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 73024 1.INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH

a.

Align the anchor plate positioning hole with the claw and install the anchor plate with the 2 bolts.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

HINT:

First install the lower bolt, and then install the upper bolt.



Hide 73220 2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

U115599E07
1.521,1.469 2.594,0.771 2.594,0.771 1.823,1.5 false 2.646,0.635 2.854,0.833 0.208,0.198 10 false a

NOTICE:

When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.


a.

Align the seat belt retractor positioning holes with the claws of the vehicle.


b.

Install the seat belt with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


c.
B241715

Connect the pretensioner connector.


d.

Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 62414A 4.INSTALL LOWER CENTER PILLAR GARNISH LH

a.

Attach the 4 claws and 2 clips to install the lower center pillar garnish.


b.

Install the front seat outer belt floor anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 73233 5.INSTALL OUTER LAP BELT ANCHOR COVER

Hide 62332C 6.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 67934 8.INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

Hide 58371F 9.INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

Hide 62312B 10.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 67920 11.INSTALL DOOR SCUFF PLATE ASSEMBLY LH

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 13.CHECK SRS WARNING LIGHT