Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM1440E _58 Vehicle Interior _056162 SEAT BELT _0274124 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67920 2.REMOVE DOOR SCUFF PLATE ASSEMBLY LH

Hide 62312B 3.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

a.

Partially remove the front door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 58371F 4.REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

Hide 67934 5.REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

Hide 67918D 6.REMOVE REAR DOOR SCUFF PLATE LH

Hide 62332C 7.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

a.

Partially remove the rear door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 73233 8.REMOVE OUTER LAP BELT ANCHOR COVER

Hide 62414A 9.REMOVE LOWER CENTER PILLAR GARNISH LH

a.
B238736

Remove the bolt and disconnect the front seat outer belt floor anchor.


b.
B238737

Detach the 4 claws and 2 clips and remove the lower center pillar garnish.


Hide 62412 10.REMOVE CENTER PILLAR GARNISH LH

Hide 73220 11.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

B241717

a.

Remove the nut and shoulder anchor.


b.
B239043

Disconnect the pretensioner connector.


c.
B245756

Remove the bolt and seat belt.


Hide 73024 12.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY

B239046

a.

Remove the 2 bolts and anchor plate.