Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT INNER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side)
RM1440E _58 Vehicle Interior _056162 SEAT BELT _0274127 REAR NO. 1 SEAT INNER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side) A

SEAT BELT  REAR NO. 1 SEAT INNER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 73390C 1.INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

B242874E01
2.985,2.262 3.183,2.470 0.198,0.208 10 *a 0.111,1.933 0.309,2.141 0.198,0.208 10 *a 0.49,2.662 0.36,2.016 0.36,2.016 0.301,2.016 false 2.918,0.62 3.092,0.672 3.092,0.672 3.092,2.228 false

a.

Install the inner belt and connect the center outer belt with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.


Text in Illustration
*a Protruding Part


Hide 8.INSTALL REAR SEAT ASSEMBLY LH