Wear protective gloves. Sharp areas on the parts may injure your hands.
73360C
1.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.
Align the claws with the seat belt positioning holes and install the retractor of the seat belt with the nut and bolt as shown in the illustration.
First install the bolt, and then install the nut.
| *1 | Bolt |
| *2 | Nut |
73187A
2.INSTALL REAR SEAT SHOULDER BELT GUIDE
71697
3.INSTALL REAR SEATBACK EDGE PROTECTOR
4.INSTALL SEATBACK COVER WITH PAD
72613B
5.INSTALL REAR SEAT LOCK STRIKER
72618
6.INSTALL REAR SEATBACK LOCK STRIKER PROTECTOR
73373
7.INSTALL REAR SEAT SHOULDER BELT COVER
73178A
8.INSTALL SEAT BELT ANCHOR COVER CAP
71931B
9.INSTALL REAR NO. 1 SEAT HEADREST SUPPORT ASSEMBLY
72661C
10.INSTALL REAR SEATBACK LOCK RELEASE BUTTON
72630C
11.INSTALL REAR SEATBACK LOCK ASSEMBLY RH
72665
12.INSTALL REAR SEATBACK LOCK COVER RH
72987
13.INSTALL REAR CENTER SEAT ARMREST COVER
14.INSTALL CENTER SEATBACK ASSEMBLY
71095S
15.INSTALL CENTER SEATBACK COVER SUB-ASSEMBLY
73460C
16.INSTALL REAR SEAT CENTER INNER BELT ASSEMBLY
71878A
17.INSTALL REAR SEAT INNER RECLINING COVER RH
79109
18.INSTALL NO. 1 SEATBACK BOARD SUB-ASSEMBLY (for Plastic Seatback Board)
79109
19.INSTALL NO. 1 SEATBACK BOARD SUB-ASSEMBLY (for Seatback Board with Carpet)
20.INSTALL REAR SEAT ASSEMBLY RH
Install the rear No. 2 seat assembly RH (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Double-folding Seat Type RH Side)>INSTALLATION).