Home › Vehicle Interior › SEAT BELT › REAR CENTER SEAT OUTER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side)
RM1440E _58 Vehicle Interior _056162 SEAT BELT _0274135 REAR CENTER SEAT OUTER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side) A

SEAT BELT  REAR CENTER SEAT OUTER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 73320A 1.INSTALL NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH

U115609E06
1.698,1.479 2.281,0.823 2.281,0.823 2,1.469 false 1.208,0.708 1.385,0.875 0.177,0.167 10 true *1 2.135,1.771 2.375,2 0.24,0.229 10 true *2 2.313,0.677 2.469,0.875 0.156,0.198 10 false a

NOTICE:

When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.


a.

Align the claws with the seat belt positioning holes and install the retractor of the seat belt with the nut and bolt as shown in the illustration.

HINT:

First install the bolt, and then install the nut.


Torque:
for bolt : 7.5 N*m (76 kgf*cm, 66 in.*lbf)
for nut : 42 N*m (428 kgf*cm, 31 ft.*lbf)

Text in Illustration
*1 Bolt
*2 Nut


Hide 73390C 12.INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

B242874E01
2.985,2.262 3.183,2.470 0.198,0.208 10 *a 0.111,1.933 0.309,2.141 0.198,0.208 10 *a 0.49,2.662 0.36,2.016 0.36,2.016 0.301,2.016 false 2.918,0.62 3.092,0.672 3.092,0.672 3.092,2.228 false

a.

Install the inner belt and connect the 3 point type belt anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not allow the anchor part of the anchor plate sub-assembly to overlap the protruding parts of the seatback frame.


Text in Illustration
*1 Protruding Part


Hide 20.INSTALL REAR NO. 1 SEAT ASSEMBLY LH