63341
1.REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)
Remove the No. 1 roof silencer pad.
63342
2.REMOVE NO. 2 ROOF SILENCER PAD
w/o Sliding Roof:
Remove the 2 No. 2 roof silencer pads.
w/ Sliding Roof:
Remove the No. 2 roof silencer pad.
63343
3.REMOVE NO. 3 ROOF SILENCER PAD (w/o Sliding Roof)
Remove the No. 3 roof silencer pad.
63344
4.REMOVE NO. 4 ROOF SILENCER PAD
w/o Sliding Roof:
Remove the No. 4 roof silencer pad.
w/ Sliding Roof:
Remove the No. 4 roof silencer pad.
81340
5.REMOVE VANITY LIGHT ASSEMBLY
Use the same procedure for the other vanity light assembly.
Detach the 2 claws labeled A and separate the bulb holder from the vanity light assembly as shown in the illustration.
Detach the claw labeled B and remove the vanity light assembly.
| *1 | Claw A |
| *2 | Claw B |
| *3 | Bulb Holder |
82171
6.REMOVE NO. 1 ROOF WIRE
Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining assembly.
Detach each clamp and remove the tape and No. 1 roof wire.
| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *C | w/ EC Mirror | - | - |
| *1 | Visor Connector | *2 | Marking Tape |
86101J
7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
w/o Sliding Roof:
(See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).
w/ Sliding Roof:
(See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).