Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274161 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2311  Back Door Power Window ECU Inner Motor Failure  


DESCRIPTION

The power window regulator motor is operated by the back door power window regulator switch. The back power window regulator motor assembly has motor and ECU functions.

This DTC is stored when the back door power window regulator motor assembly has a malfunction, or the ECU built into the regulator motor determines that the fully closed window position has deviated approximately 20 mm (0.787 in.) or more from the normal position.

HINT:

DTC B2311 can be stored in back door power window regulator motor (power window ECU).


Back Door P/W
DTC Code DTC Detection Condition Trouble Area
B2311

Either condition is met:

1.

Back door power window regulator motor malfunctions.

2.

ECU in the back door power window regulator motor determines that the fully closed window position has deviated approx. 20 mm (0.787 in.) or more from the normal position.



Back door power window regulator motor

CAUTION / NOTICE / HINT

NOTICE:
·

When a power window regulator motor is reinstalled or replaced, the power window control system must be initialized.

·

After any door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be reinitialized by repeating the following operations at least 5 times:

1.

Close the power window by fully pulling up the multiplex network master switch or back door power window regulator switch and holding it in the auto up position.

2.

Open the power window by fully pushing down the switch.




PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (POWER WINDOW)
a.

Select the Active Test, use the intelligent tester to generate a control command, and then check that the back door power window regulator motor operates (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Back Door P/W
Tester Display Test Part Control Range Diagnostic Note
Back Door Power Window Back door power window OFF/UP/DOWN -

OK:

The back door power window regulator motor operates.




OK

2.PERFORM INITIALIZATION

NG

REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY

2.PERFORM INITIALIZATION
a.

Initialize the back door power window regulator motor assembly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).


b.

Check that the back door power window operates normally by opening and closing the window (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

HINT:

The power window operates normally.




NEXT

3.CHECK WHETHER PARTS HAVE BEEN INSTALLED CORRECTLY
3.CHECK WHETHER PARTS HAVE BEEN INSTALLED CORRECTLY
a.

Check that the power window components are installed correctly.

OK:

Power window components are installed correctly.


HINT:

If the power window components are installed correctly, the problem has been caused by battery disconnection while the ignition switch was ON, or the motor being overheated.




OK

END

NG

INSTALL PARTS CORRECTLY