Home › Vehicle Exterior › WINDOW / GLASS › BACK DOOR POWER WINDOW MOTOR › 2009.08–2012.08
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274168 BACK DOOR POWER WINDOW MOTOR A

WINDOW / GLASS  BACK DOOR POWER WINDOW MOTOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 64780A 2.REMOVE BACK DOOR TRIM PANEL ASSEMBLY

Hide 86160Y 3.REMOVE REAR NO. 2 SPEAKER ASSEMBLY

Hide 89222A 4.REMOVE MULTIPLEX NETWORK DOOR ECU

Hide 67848C 5.REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER

Hide 67848 6.REMOVE BACK DOOR SERVICE HOLE COVER LH

Hide 67847 7.REMOVE BACK DOOR SERVICE HOLE COVER RH

Hide 76893 10.REMOVE REAR NO. 1 SPOILER COVER

Hide 76085 11.REMOVE REAR SPOILER SUB-ASSEMBLY

Hide 67381A 13.REMOVE NO. 1 BACK WINDOW WIPER MOTOR BRACKET

Hide 85120R 14.REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY

Hide 68275 15.REMOVE BACK DOOR GLASS RUN

Hide 68131 16.REMOVE BACK DOOR GLASS

Hide 68290A 17.REMOVE OUTER BACK DOOR GLASS WEATHERSTRIP ASSEMBLY

Hide 69807 18.REMOVE BACK DOOR POWER WINDOW REGULATOR SUB-ASSEMBLY

Hide 85720E 19.REMOVE BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY

B240224

a.

Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor.

NOTICE:

Be careful when removing the screws as the motor may fall and become damaged.