Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Front Door)
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274165 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67492A 2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 69298A 3.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

Hide 67602 4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 68172A 5.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

Hide 86160 6.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

Hide 67832 7.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 68102 8.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 69802 9.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 85720C 10.REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.
B238534

Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor.

B238976E03
5.352,0.102 5.604,0.290 0.252,0.188 10 *a 5.857,2.354 6.095,2.506 0.238,0.152 10 *1 5.537,1.96 5.863,2.346 false

Text in Illustration
*1 Spring - -
*a Range of Movement - -

CAUTION:

Do not place your finger, etc. within the range of movement of the window regulator. When removing the power window regulator motor, the force of the spring causes the window regulator to move in the direction of the arrow shown in the illustration (the direction in which the window rises), which may cause injury.


NOTICE:

Be careful when removing the screws as the motor may fall and become damaged.