Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
63310
1.REMOVE ROOF HEADLINING ASSEMBLY
62440
2.REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH
Detach the 3 clips.
Cut off the 3 clips to remove the roof side rail garnish assembly LH.
Remove the 3 clips from the vehicle body.
| *1 | Clip |
3.DISCONNECT WINDOW GLASS ANTENNA WIRE
Disconnect the window glass antenna wire connector (for LH side).
Disconnect the window glass antenna wire connector (for RH side).
62740B
4.REMOVE REAR QUARTER WINDOW ASSEMBLY LH
From the interior, insert a piano wire between the vehicle body and rear quarter window assembly LH as shown in the illustration.
| *1 | Protective Tape |
| *2 | Piano Wire |
When separating the rear quarter window assembly LH from the vehicle body, be careful not to damage the vehicle paint or interior/exterior ornaments.
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut through the adhesive by pulling the piano wire around the rear quarter window assembly LH.
Leave as much adhesive on the vehicle body as possible when removing the rear quarter window assembly LH.
Using suction cups, remove the rear quarter window assembly LH.
5.CLEAN VEHICLE BODY
Clean and shape the contact surface of the vehicle body.
| *1 | Adhesive |
| *2 | Vehicle Body |
On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.
Be careful not to damage the vehicle body.
Leave as much adhesive on the vehicle body as possible.
Clean the contact surface of the vehicle body with cleaner.
Even if all the adhesive has been removed, clean the vehicle body.