Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
87940
1.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
Attach the claw to install the outer rear view mirror, and then install the 3 nuts.
Connect the connector.
68172A
2.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH
67602
3.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
69298A
4.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
67492A
5.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH