Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2009.08–2010.08
RM1440E _59 Vehicle Exterior _056173 EXTERIOR PANELS / TRIM _0274217 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 52103 1.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH

a.

Install the front bumper bracket with the 2 bolts.


Hide 52102 2.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52521 3.INSTALL UPPER CENTER FRONT BUMPER RETAINER

a.

Install the upper center front bumper retainer with the 2 bolts.


Hide 52116A 4.INSTALL FRONT BUMPER SIDE SUPPORT LH

a.

Attach the 2 claws to install the front bumper side support.


b.

Install the screw.


Hide 52115A 5.INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure described for the LH side.


Hide 81135 7.INSTALL HEADLIGHT UNIT RH

HINT:

Use the same procedure described for the LH side.


Hide 52134J 8.INSTALL FRONT BUMPER BAR REINFORCEMENT LH

a.

Install the front bumper bar reinforcement with the 2 screws.


Hide 52133J 9.INSTALL FRONT BUMPER BAR REINFORCEMENT RH

HINT:

Use the same procedure described for the LH side.


Hide 52026B 10.INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH

a.

Install the No. 2 front bumper extension with the 4 bolts.

Torque:
65 N*m (663 kgf*cm, 48 ft.*lbf)


Hide 52025B 11.INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52021 12.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY

a.

Install the front bumper reinforcement with the 6 nuts.

Torque:
30 N*m (306 kgf*cm, 21 ft.*lbf)


Hide 52611 13.INSTALL FRONT BUMPER ENERGY ABSORBER

a.

Install the front bumper energy absorber.


Hide 52129B 14.INSTALL FRONT BUMPER LOWER COVER

a.

Install the front bumper lower cover with the 5 bolts and clip.


Hide 52119A 15.INSTALL FRONT BUMPER COVER

a.

Attach the 10 claws to install the front bumper cover.


b.

Install the 2 bolts, 10 screws and 4 clips.


Hide 18.ADJUST HEADLIGHT AIMING

a.

Adjust the headlight aiming (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>ADJUSTMENT).


Hide 19.ADJUST FOG LIGHT AIMING

a.

Adjust the fog light aiming (See page Vehicle Exterior>LIGHTING (EXT)>FOG LIGHT ASSEMBLY>ADJUSTMENT).