A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
52103
1.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH
Install the front bumper bracket sub-assembly LH with the 2 bolts.
52102
2.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
52521
3.INSTALL UPPER CENTER FRONT BUMPER RETAINER
Install the upper center front bumper retainer with the 2 bolts.
52116A
4.INSTALL FRONT BUMPER SIDE SUPPORT LH
Attach the 2 claws to install the front bumper side support LH.
Install the screw.
52115A
5.INSTALL FRONT BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
81175
6.INSTALL HEADLIGHT UNIT LH
81135
7.INSTALL HEADLIGHT UNIT RH
Use the same procedure described for the LH side.
52134J
8.INSTALL FRONT BUMPER BAR REINFORCEMENT LH
Install the front bumper bar reinforcement LH with the 2 screws.
52133J
9.INSTALL FRONT BUMPER BAR REINFORCEMENT RH
Use the same procedure described for the LH side.
52026B
10.INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH
Install the No. 2 front bumper extension sub-assembly LH with the 4 bolts.
52025B
11.INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
52021
12.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
Install the front bumper reinforcement sub-assembly with the 6 nuts.
52611
13.INSTALL FRONT BUMPER ENERGY ABSORBER
Install the front bumper energy absorber.
52129B
14.INSTALL FRONT BUMPER LOWER COVER
Install the front bumper lower cover with the 5 bolts and clip.
52119A
15.INSTALL FRONT BUMPER COVER
Attach the 12 claws to install the front bumper cover.
Install the 2 bolts, 10 screws and 4 clips.
53111
16.INSTALL RADIATOR GRILLE
53292A
17.INSTALL UPPER RADIATOR SUPPORT SEAL
18.ADJUST FOG LIGHT AIMING
19.ADJUST HEADLIGHT AIMING