A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
52103
1.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH
Install the front bumper bracket sub-assembly LH with the 2 bolts.
52102
2.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
52116A
3.INSTALL FRONT BUMPER SIDE SUPPORT LH
Attach the 2 claws to install the front bumper side support LH.
Install the screw and bolt.
52115A
4.INSTALL FRONT BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
52026B
5.INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH
Install the No. 2 front bumper extension sub-assembly LH with the 4 bolts.
52025B
6.INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
52021
7.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
Install the front bumper reinforcement sub-assembly with the 6 nuts and screw.
52611
8.INSTALL FRONT BUMPER ENERGY ABSORBER
Install the front bumper energy absorber.
53294C
9.INSTALL RADIATOR SIDE DEFLECTOR LH
53293C
10.INSTALL RADIATOR SIDE DEFLECTOR RH
52129B
11.INSTALL FRONT BUMPER LOWER COVER
Install the front bumper lower cover with the 5 bolts and clip.
52521
12.INSTALL UPPER CENTER FRONT BUMPER RETAINER
52119A
13.INSTALL FRONT BUMPER COVER
Connect the 2 connectors.
Attach the 14 claws to install the front bumper cover with radiator grille.
Install the 3 bolts, 10 screws and 6 clips.
53292A
14.INSTALL UPPER RADIATOR SUPPORT SEAL
15.ADJUST FOG LIGHT AIMING