Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › from 2013.08
RM1440E _59 Vehicle Exterior _056173 EXTERIOR PANELS / TRIM _0274219 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 51909B 1.INSTALL PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ Pintle Hook)

a.

Install the pintle hook support tube sub-assembly with the 6 bolts.

Torque:
81 N*m (826 kgf*cm, 60 ft.*lbf)


Hide 52563D 2.INSTALL REAR BUMPER UPPER RETAINER LH

a.

Attach the 2 clips to install the rear bumper upper retainer LH.


Hide 52562E 3.INSTALL REAR BUMPER UPPER RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 81561D 4.INSTALL REAR COMBINATION LIGHT LENS AND BODY LH

Hide 81551D 5.INSTALL REAR COMBINATION LIGHT LENS AND BODY RH

HINT:

Use the same procedure as for the LH side.


Hide 52156A 6.INSTALL REAR BUMPER SIDE SUPPORT LH

a.

Attach the 5 claws to install the rear bumper side support LH.


b.

Install the 3 screws.


Hide 52155A 7.INSTALL REAR BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure as for the LH side.


Hide 52174D 8.INSTALL REAR BUMPER BAR REINFORCEMENT LH

a.

Install the rear bumper bar reinforcement LH with the 3 bolts.


Hide 52173D 9.INSTALL REAR BUMPER BAR REINFORCEMENT RH

HINT:

Use the same procedure as for the LH side.


Hide 52615 10.INSTALL REAR BUMPER ENERGY ABSORBER

a.

Install the rear bumper energy absorber.


Hide 52159 11.INSTALL REAR BUMPER COVER

a.

Attach the 18 claws to install the rear bumper cover.


b.

Install the 8 bolts and 4 screws.


Hide 76626E 12.INSTALL REAR QUARTER PANEL MUDGUARD LH

Hide 76625G 13.INSTALL REAR QUARTER PANEL MUDGUARD RH

HINT:

Use the same procedure as for the LH side.


Hide 58766A 14.INSTALL JACK BOX HOLE COVER

a.

Attach the 2 guides and 2 claws to install the jack box hole cover.