Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING
RM1440E _59 Vehicle Exterior _056173 EXTERIOR PANELS / TRIM _0274226 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 75722A 1.INSTALL REAR DOOR BELT MOULDING LH

a.

Attach the 7 claws to install the rear door belt moulding.


Hide 68104 2.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 68124C 3.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 67408F 4.INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 68152C 5.INSTALL REAR DOOR GLASS RUN LH

Hide 67842E 6.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 68174A 7.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

Hide 67604 8.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 69278C 9.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).