Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
76622D
1.REMOVE FRONT FENDER MUDGUARD LH (for X-Runner)
75852
2.REMOVE ROCKER PANEL MOULDING LH (for X-Runner)
75602A
3.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH
Put protective tape around the front fender moulding.
| *1 | Protective Tape |
Remove the 6 screws.
Detach the 9 clips and remove the front fender moulding.
Remove the 9 clips.
75742
4.REMOVE REAR DOOR OUTSIDE MOULDING LH
Put protective tape around the rear quarter panel moulding.
Detach the 7 clips and 2 claws and remove the rear door outside moulding.
Remove the 7 clips.
75394A
5.REMOVE NO. 3 OUTSIDE MOULDING RETAINER
Remove the screw.
Detach the claw and remove the No. 3 outside moulding retainer.
75654A
6.REMOVE REAR QUARTER OUTSIDE MOULDING LH
Put protective tape around the rear quarter outside moulding LH.
| *1 | Protective Tape |
Remove the 2 screws.
Detach the 4 clips and remove the rear quarter outside moulding.
Remove the 4 clips.