Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR WINDOW FRAME MOULDING
RM1440E _59 Vehicle Exterior _056173 EXTERIOR PANELS / TRIM _0274230 FRONT DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR WINDOW FRAME MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When removing window frame moulding, heat the vehicle body and window frame moulding using a heat light.

Standard:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)




NOTICE:

Do not heat the vehicle body or window frame moulding excessively.


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67492A 2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 69298A 3.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

Hide 67602 4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 68172A 5.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

Hide 67832 6.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 87940 7.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Hide 68102 8.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 68151E 9.REMOVE FRONT DOOR GLASS RUN LH

Hide 67862 11.REMOVE FRONT DOOR WEATHERSTRIP LH

B242363

a.

Detach the 3 clips and remove the upper part of the front door weatherstrip so that the moulding can be removed.


Hide 75756C 12.REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH

a.
B243888

Remove the door window frame moulding clip.


b.
B243889E02
2.691,0.085 2.874,0.241 0.184,0.156 10 *1 1.169,1.783 1.370,1.952 0.201,0.170 10 *2 0.478,2.711 0.693,2.887 0.215,0.177 10 *1 2.663,2.148 2.864,2.352 0.201,0.205 10 *2 2.681,0.194 2.457,0.194 2.457,0.194 2.357,0.283 false 1.371,1.87 1.881,1.87 false 2.188,2.24 2.638,2.24 false 0.661,2.798 0.893,2.798 0.893,2.798 1.042,3.216 false 1.139,1.121 1.313,1.266 0.173,0.145 10 *3 1.354,1.203 1.569,1.203 1.569,1.203 1.848,1.104 false

Put protective tape around the front door rear window frame moulding.

Text in Illustration
*1 Protective Tape
*2 Double-sided Tape
*3 Moulding Remover


c.

Using a moulding remover, detach the clip and remove the double-sided tape to remove the front door rear window frame moulding.