Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR WINDOW FRAME MOULDING
RM1440E _59 Vehicle Exterior _056173 EXTERIOR PANELS / TRIM _0274231 REAR DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR WINDOW FRAME MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When removing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.

Standard:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)




NOTICE:

Do not heat the vehicle body or window frame moulding excessively.


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 69278C 2.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

Hide 67604 3.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 68174A 4.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

Hide 67842E 5.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 68152C 6.REMOVE REAR DOOR GLASS RUN LH

Hide 67408F 7.REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 68124C 8.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

Hide 68104 9.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 67872 11.REMOVE REAR DOOR WEATHERSTRIP LH

B242553

a.

Detach the clip and remove the upper part of the rear door weatherstrip so that the moulding can be removed.


Hide 75762A 12.REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING LH

B242554

a.

Remove the door window frame moulding clip.


b.

Detach the clip and remove the double-sided tape to remove the rear door front window frame moulding.