53111
1.REMOVE RADIATOR GRILLE
82112
2.REMOVE NO. 2 ENGINE ROOM WIRE
Disconnect each connector.
Detach the 9 clamps to remove the No. 2 engine room wire.
89341A
3.REMOVE NO. 1 ULTRASONIC SENSOR
89348D
4.REMOVE ULTRASONIC SENSOR CLIP
89348A
5.REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
52114A
6.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (w/ License Plate Bracket)
Remove the 2 screws and front bumper extension mounting bracket.
52713A
7.REMOVE FRONT BUMPER SIDE MOULDING LH
Remove the 2 outside moulding retainers.
Detach the claws to remove the front bumper side moulding LH.
52712
8.REMOVE FRONT BUMPER SIDE MOULDING RH
Use the same procedure as for the LH side.
52676
9.REMOVE FRONT BUMPER LOWER SIDE SUPPORT LH
Remove the 2 clips.
Detach the 5 claws to remove the front bumper lower side support LH.
52675
10.REMOVE FRONT BUMPER LOWER SIDE SUPPORT RH
Use the same procedure as for the LH side.
53122B
11.REMOVE NO. 2 RADIATOR GRILLE MOULDING
Remove the 2 outside moulding retainers and 4 screws.
Detach the 4 claws to remove the No. 2 radiator grille moulding.
52703
12.REMOVE FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY LH
Remove the 3 outside moulding retainers.
Remove the 2 screws.
Detach the 2 claws and guide to remove the front bumper side moulding sub-assembly LH.
52702
13.REMOVE FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
52701
14.REMOVE FRONT BUMPER MOULDING SUB-ASSEMBLY
Remove the 4 screws.
Remove the 15 outside moulding retainers.
Detach the 12 guides and 4 claws to remove the front bumper moulding sub-assembly.
81220
15.REMOVE FOG LIGHT ASSEMBLY LH
81210A
16.REMOVE FOG LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.